Selleys Power Grip All Plastics is a specially formulated adhesive and primer system which delivers a strong bond on all plastics*, even polyethylene, polypropylene and ABS. It also bonds plastics to non-plastic surfaces.
Packaging
3+3mL Tube
(Primer 3ml + Glue 3ml)
What materials is this product suit for?
Plastics*
Metal
Wood
Leather
Ceramics
Ensure surfaces are close fitting, clean, dry and free of dust.
Using the primer pen, apply one coat to each plastic surface to be bonded. If primer pen appears dry, test by drawing a line on a piece of paper, a wet mark should be evident.
Pierce seal at end of adhesive tube by attaching nozzle and cap and turning clockwise.
Remove cap and apply a small amount of glue to one surface only.
Bring surfaces together and apply slight pressure until adhesive grabs (30 seconds). Allow at least 30 minutes for sufficient bond strength for practical use.
Wipe tip of tube, replace cap and store upright in a dry cool place. Ensure cap on primer pen is tightly closed.
*Does not work on PTFE. Not suitable for glass or foam. Product only works on some rubbers.
If using on leather or clear plastic, test on an inconspicuous area first as adhesive may discolour or cause leather to harden.
Safety Tips:
Keep out of reach of children.
Avoid contact with skin, eyes and avoid breathing in vapour. Use only in well-ventilated area.
Bonds on contact. Should fingers stick together, apply a solvent such as acetone (nail polish remover) to contact areas then wash with water.
Do not use solvent near eyes or open wounds. In case of eye contact, immediately flush with water for at least 15 minutes and seek medical attention.